alpos cup_rotate_pos crp Trendsetter_400/800_Auto This value specifies the absolute distance in mm between the HOME position and the ROTATE position for the unload traveller. This distance is used by the TABLE MOVE ROTATE command and by the PROCESS command. uint32

628

0 to 1000 [mm]

This value MUST be adjusted so that the "table move rotate" command positions the traveller sensor tab in the center of the rotate position optical sensor (note that the traveller must be HOMED using the "table move home" command first). cal

../commands/process.xmlCommand: process

../commands/table.xmlCommand: table

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:36:20 2008 PST